SRAM Level Disc Brake Lever Hose Boot

These boots are specifically designed for the Stealth version of the Level Ultimate, Silver, and Bronze brake levers. They will not fit older, non-Stealth Level models due to the different lever body architecture.

The hose boot acts as a protective seal where the hydraulic line enters the lever body. If it becomes torn or brittle, it can allow dirt and debris to compromise the connection point, potentially leading to premature wear or contamination of the hydraulic system.

No special tools are required. You can typically slide the old boot off and press the new one into place by hand, though you may need to carefully disconnect the hydraulic hose at the lever if you are performing a full service.

Yes, this package contains two boots, which is exactly what you need to service both the front and rear brake levers on a single bicycle.

Not necessarily. If you are just replacing the rubber boot, you can often slide it over the hose fitting without disconnecting the hydraulic line. However, if you need to remove the hose entirely to slide the boot on, you will need to bleed the system afterward.