RockShox Reba Crown/Steerer/Uppertube Assembly

No, this is strictly the upper chassis assembly. It includes the crown, steerer tube, and upper tubes (stanchions) only, so you will need to transfer your existing lower legs and internal air/damper components over to this new unit.

This assembly is designed specifically for the RockShox Reba A7 generation. You should check the serial number on the back of your fork crown or the lower leg to confirm your model generation and travel length before purchasing.

Not necessarily. While this assembly is built for 120mm of travel, the travel is often determined by the air spring shaft inside your fork. Simply swapping the upper assembly won't change your travel unless you also install the correct air spring shaft for your desired length.

RockShox presses the stanchions into the crown at the factory to ensure precise alignment and structural integrity. Replacing the entire assembly is the only way to guarantee the fork remains straight and safe if the stanchions are bent or the steerer tube is damaged.

No, this assembly features a tapered steerer tube. It will only fit frames designed for tapered headtubes (1-1/8" to 1.5") and cannot be adapted to fit straight 1-1/8" headtubes.