Mavic ID360 Freehub Body

This freehub body is specifically designed for Mavic wheels equipped with the ID360 hub system. You can verify compatibility by checking if your rear hub is labeled as ID360 or by referencing the technical documentation for your specific wheel model.

Yes, this component is designed to convert your existing Mavic ID360 hub to accept SRAM XDR cassettes. It is the necessary bridge for running a 12-speed SRAM road or gravel drivetrain on your current wheelset.

Generally, the ID360 system is designed for tool-free removal, allowing you to pull the old freehub body off by hand after removing the cassette and end cap. However, it is always a good idea to have a clean workspace and fresh freehub oil on hand to ensure smooth engagement upon reassembly.

While not strictly required, it is highly recommended to inspect the pawls and springs for wear while the hub is disassembled. If they show signs of fatigue or rounding, replacing them at the same time as the freehub body will ensure consistent engagement and prevent potential slippage.

No, this is a direct replacement part that maintains your wheel's existing axle standard and spacing. It simply changes the interface where the cassette mounts, without altering the geometry of the hub itself.