Matrix Butterfly Airsoft LiPo Battery

An 11.1V LiPo provides a significant increase in rate of fire and trigger response, but it can cause premature wear on guns with standard internal components. We recommend using this battery only if your AEG has a MOSFET installed or upgraded internal gears and a piston to handle the higher voltage.

The butterfly configuration splits the battery cells into two or three separate sticks connected by wires. This design is specifically intended to fit into tight spaces, such as inside crane stocks, buffer tubes, or specific handguards where a single rectangular brick battery would not fit.

Yes, you must use a dedicated LiPo balance charger. Because this battery uses an XH 4-pin balance connector, your charger needs to be compatible with that plug to safely monitor and balance the voltage of each individual cell during the charging process.

Check the dimensions of your battery compartment first. This unit measures 7mm x 22mm x 120mm per cell. If your stock or handguard has at least these internal dimensions, it should fit, but always measure your available space before purchasing.

The 20C discharge rate indicates how much power the battery can safely deliver to the motor at once. This rating is sufficient for most standard to mid-range builds, ensuring the motor gets enough current to cycle the gearbox without the battery overheating or struggling under load.