RockShox Reba Damper Assembly

You likely need a replacement if your lockout lever no longer firms up the fork, if you notice oil leaking from the top compression adjuster, or if the fork feels inconsistent and harsh despite proper air pressure settings.

Yes, this assembly is designed to work with both configurations. However, you may need to ensure you have the correct top cap or cable interface hardware specific to your existing setup.

If you are comfortable performing basic suspension service, this is a manageable task. You will need a cassette tool or a specific socket to remove the top cap, along with fresh suspension oil to refill the damper side during reassembly.

It should restore the fork to its original, factory-fresh damping performance. If your old damper was worn or leaking, you will notice a significant improvement in responsiveness and control on the trail.

This assembly typically comes as a complete unit with the necessary seals pre-installed. It is always good practice to check your fork's specific service manual to see if you need additional crush washers or O-rings for the lower legs during the service.