Strike Industries Shotgun Barrel Clamp

It is designed to fit standard 12-gauge shotgun barrels, but it may not be compatible with barrels that have unusual contours, heat shields, or specific ribbing patterns. We recommend checking your barrel's outer diameter against the clamp's specifications before purchasing.

The clamp provides a single mounting point. If you need to attach multiple accessories, you would likely need to look into a rail adapter or a different mounting system, as this unit is designed for a streamlined, low-profile setup.

While the clamp is designed for a secure, metal-on-metal fit, it is always a good practice to apply a small piece of electrical tape or a thin protective layer between the clamp and the barrel if you are concerned about preserving the finish.

Compatibility depends on the clearance between your barrel and the magazine tube. Because this clamp adds a small amount of bulk to the exterior of the barrel, it may interfere with magazine tubes that sit flush against the barrel.

Installation is straightforward and typically requires only standard hex keys. You should ensure the screws are tightened evenly to maintain a secure hold without over-torquing the hardware.