Cobra 3DP Tour Agera Putter

The 3D-printed lattice allows Cobra to remove weight from the center of the putter head and redistribute it to the perimeter. This increases the moment of inertia, which helps the putter resist twisting on off-center hits for better forgiveness.

This technology varies the loft across the face to ensure a consistent launch angle, even if your hands are slightly forward or backward at impact. It promotes a true end-over-end roll, helping the ball start on your intended line more reliably.

The Agera is designed with a single-bend shaft and a counterbalanced profile, making it best suited for golfers with a neutral, straight-back-straight-through putting stroke. If you have a significant arc in your stroke, you may find it harder to square the face at impact.

Yes, the putter features an adjustable weighting system. This allows you to fine-tune the head weight to match your preferred feel and tempo on the greens.

At 38 inches, this is a longer shaft designed for a counterbalanced setup, which helps stabilize your hands and wrists during the stroke. You should grip the club as you normally would, but you may find that the extra length encourages a more upright, pendulum-like motion.

The precision-milled 304 stainless steel face provides a crisp, firm feedback at impact. It is designed to give you clear tactile information about where you struck the ball on the face, which is helpful for developing distance control.