Gate Titan V2

The Titan V2 is designed specifically for AEGs using a Version 2 gearbox, such as the M4 platform. While it is highly compatible with most standard V2 gearboxes, some proprietary or uniquely shaped shells may require minor modification for a perfect fit.

No, the Titan V2 is a drop-in module designed to replace your existing trigger contacts without the need for soldering. It is a plug-and-play solution, though you will need to disassemble your gearbox to install the optical sensor board correctly.

You configure the unit using the included USB-Link, which connects the Titan to your computer or mobile device. Through the Gate software interface, you can adjust trigger sensitivity, firing modes, and pre-cocking settings in real-time.

The integrated battery protection monitors your voltage levels in real-time to prevent over-discharge. If your battery voltage drops below a safe threshold, the system will provide an audible warning or cut power to protect your LiPo battery from permanent damage.

This specific kit is configured for rear-wired setups, meaning the wiring harness is designed to route through the buffer tube or stock. While you could technically adapt it for a front-wired gun, it would require significant custom wiring work and is not recommended for most users.

Pre-cocking pulls the piston back to a ready position after every shot, meaning the spring is already compressed when you pull the trigger. This results in a near-instantaneous shot release, significantly improving your trigger response time compared to a stock AEG.