Waterway Plastics E-Series Wet End

This model is designed specifically for 48-frame thru-bolt motors. Before purchasing, check your current motor label to confirm it is a 48-frame size, as it will not fit 56-frame motors.

While it is a direct replacement for Waterway E-Series center-discharge models, compatibility with other brands depends on the bolt pattern and plumbing alignment. We recommend verifying that your current pump uses a center-discharge configuration and a 6-screw faceplate design to ensure a proper fit.

The 6-screw configuration is a modern update that provides a more uniform clamping force around the seal compared to older 4-screw models. This design helps prevent common leaks and ensures a more secure, long-lasting connection.

Yes, the unit includes the essential seals required for assembly. However, it is always good practice to inspect your existing plumbing unions to ensure they are in good condition, as you may need to replace old O-rings or unions during the installation process.

No, this specific model is engineered for 1.5-inch suction and discharge connections. If your current plumbing is 2 inches, you would need to use appropriate reducer bushings to adapt the lines, though we generally recommend matching the wet end to your existing pipe size for optimal flow.