Cane Creek VALT Rear Shock Spring

The VALT spring uses a progressive rate curve, meaning it starts to ramp up resistance at the 50% mark of the stroke. This design provides better bottom-out resistance on big hits while keeping the initial stroke sensitive to small trail chatter.

This spring has an inner diameter of 36.5mm and is specifically engineered for Cane Creek coil shocks. You should verify your shock's specific spring requirements and inner diameter compatibility before purchasing to ensure a proper fit.

Yes, the VALT is constructed from high-performance steel that allows for a lighter overall weight without sacrificing durability. It bridges the gap between the weight savings of titanium and the reliability of traditional steel.

Spring rate selection depends on your rider weight, bike leverage ratio, and personal preference for suspension feel. We recommend using a spring rate calculator specific to your bike frame's kinematics to determine if this range suits your setup.

Because the progression kicks in mid-stroke, it primarily affects how the shock behaves under compression rather than your static sag. You should still aim for your manufacturer's recommended sag percentage, but you may find you can run slightly less preload than a linear spring.