RockShox Reverb Remote

These barbs are designed for standard Reverb hydraulic systems. However, if you are running a very early generation Reverb or a specialized electronic AXS model, verify your specific hose diameter and connection type before installation, as some older or newer systems utilize different fitting standards.

You will need a sharp hose cutter to ensure a clean, square cut on the hydraulic line, along with a T8 Torx wrench or the specific barb installation tool provided in standard Reverb bleed kits. Using pliers or improper tools can crush the barb or damage the hose, leading to potential leaks.

These are considered a consumable item. If you are shortening your hose length, performing a full system bleed, or servicing multiple bikes in your household, having spares on hand is essential. Once a barb is installed and removed, it is often best practice to use a fresh one to ensure a perfect, leak-free seal.

Yes. Any time you disconnect the hydraulic line or replace a fitting, air will inevitably enter the system. You will need to perform a full bleed of the Reverb remote and post to ensure consistent, responsive actuation.

It is strongly recommended that you use a new barb. Barbs are designed to bite into the inner wall of the hydraulic hose to create a pressure-tight seal; once removed, the barb's integrity is compromised and it may not seat securely, leading to hydraulic fluid leaks or remote failure.