Hayes Brake Tubing Kit HFX-9

No, this kit is specifically engineered for the Hayes HFX-9 braking system. Using it with other brake models may result in improper fitment, fluid leaks, or compromised braking performance.

900mm is a standard length that works well for most front brake setups on mountain bikes. However, you should measure your existing hose from the caliper to the lever to ensure this length provides enough slack for your specific handlebar height and steering range.

Inline routing refers to the straight-line connection point where the hose meets the brake lever or caliper. This kit is designed for systems that require this specific straight-fitting configuration rather than a banjo-style or angled connection.

This kit is designed to provide the necessary tubing for a complete setup, but installation typically requires specific hydraulic fluid and a bleed kit to remove air from the system. Consult your HFX-9 service manual to confirm if you need any additional small parts like olives or barbs, which are sometimes sold separately.

Yes, you can trim the hose to fit your specific bike geometry. You will need a sharp hose cutter to ensure a clean, square cut, and you must use a new barb and olive to create a secure, leak-free seal after trimming.