Radial Engineering Reamp Station Reamper & Direct Box

It streamlines your workflow by allowing you to record a clean, direct signal from your instrument and then easily send that recorded track back out to your amplifiers or effects pedals during the mixing process. This saves you from having to swap cables or use separate devices for each stage of the recording chain.

The DI section is powered by 48V phantom power from your audio interface or mixing console. The reamper section is passive and does not require any power to function.

Yes, the 3.5mm input is designed to accept line-level signals from mobile devices or computers, allowing you to run digital tracks or software instruments through your physical guitar amps and pedals.

Yes, it is compatible with Radial's SA series rack mount kits, which allow you to secure the unit into a standard equipment rack for a cleaner, more permanent studio integration.

The active DI circuit is based on the acclaimed Radial J48, known for its clean signal capture and high headroom. It is designed to preserve the natural tone of your instrument without adding unwanted coloration.

The reamper output uses a standard 1/4-inch jack, so you can connect it directly to your pedalboard or amplifier using standard instrument cables. It is designed to handle the impedance requirements of guitar gear, so no special adapters are necessary.