Wheels Manufacturing Thread Together Bottom Bracket

Standard press-fit bottom brackets rely on a friction fit, which can loosen over time and cause creaking. This unit uses a threaded sleeve that connects the two cups together, locking them securely in place and eliminating the movement that typically leads to noise.

Yes, this bottom bracket is specifically designed for 24mm spindle cranksets, including Shimano Hollowtech II, FSA MegaExo, and RaceFace EXI standards.

Angular contact bearings are designed to handle both radial and axial (side-to-side) loads more effectively than standard cartridge bearings. This results in smoother rotation and increased durability, especially when you are putting power through the pedals.

Yes, the Enduro bearings used in this bottom bracket are replaceable. You do not need to discard the entire unit when the bearings eventually reach the end of their service life.

Yes, you will need a specific bottom bracket tool compatible with Wheels Manufacturing threaded cups to tighten the two sides together. It is a straightforward installation, but you should ensure you have the correct wrench interface before starting.

Yes, this bottom bracket is designed to fit frames with either an 86mm or 92mm shell width, provided they have the standard 41mm bottom bracket shell inner diameter.